P3044 Engine Trouble Code
Meaning of P3044 engine trouble code is a kind of powertrain trouble code and P3044 if your catalytic convertor fails completely, you eventually won't be able to keep the car running. Your gas mileage will also be terrible, so you should try and fix it as soon as you can. Unfortunately, the average replacement cost is around $2,140 and you can't do it yourself unless you're an experienced mechanic.
P3044 Fault Symptoms :
|
If one of these reasons for P3044 code is occuring now you should check P3044 repair processes.
Now don't ask yourself; What should you do with P3044 code ? The solution is here : |
P3044 Possible Solution:
Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged. |
P3044 Code Meaning :
P | 3 | 0 | 4 | 4 |
---|---|---|---|---|
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine | Ignition System Or Misfire | Ambient Air Temperature Sensor Circuit Low | Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector) | Timing Reference High Resolution Signal A Too Many Pulses |
The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.
P3044 OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionP3044 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.Main reason For P3044 CodeThe reason of P3044 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low. |
P3044 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.